Git: merging after a revert

As it happened, I managed to merge a feature branch into our mainline that was not completely finished. After trying to fix it directly in the mainline I figured out that the best thing to do is to revert my changes in master and continue in a feature branch.

Time has come to merge again.

I tried the usual:

$ git checkout master 
$ git merge my-feature-branch 

This of course resulted in a great number of conflicts and some files from the feature branch completely missing in the mainline because git saw the files deleted by my revert commit in the mainline, while they weren’t touched in the feature branch. Git therefore quite reasonably assumed that, as the deletes in mainline were newer than the version in feature, keeping them deleted is the right thing to do. Other conflicts were caused by files having been deleted in the mainline but changed in the feature branch. Git doesn’t know what to do with these (I wouldn’t either if I were it 😉 ).

So that didn’t go too well I thought. Feeling defeated I had to:

$ git merge --abort

After a bit of googling, the answer seemed to be “revert the revert and then merge”. And yes, it worked! 🙂

$git revert <my-revert-commit-hash> 
$git merge my-feature-branch 

By reverting the revert I effectively put the mainline into a state where it contained the files from the feature branch in a form that also exists on the feature branch (the commit hashes of course don’t match but the 3-way merge has a much better starting point than with the files altogether missing). After that, the merge could figure out the changes I made in the feature branch and update the affected files. I was even lucky enough to get no conflicts – even though theoretically the conflicts could have occured both during the revert and during the merge.

Posted in git. 2 Comments »
%d bloggers like this: